Compatible-systems MicroRouter 900i Bedienungsanleitung PDF herunterladen (Seite 27)

Chapter 6 - Basic Configuration Guide 21

parameters will depend on the line communications device you are

using.

v Note: Frame Relay and SMDS are presently supported in the

MicroRouter 900i only via synchronous operation. An external clock

signal is generated for Frame Relay.

CV: Use the Physical Configuration: WAN 0 Dialog Box.

TB: Use configure and set the LinkType keyword or other keywords

in the RS232 Interface WAN 0 section.

PPP Configuration

This section covers the settings required for PPP (point-to-point)

protocol operation of the WAN interfaces.

Link Configuration

Required for Dedicated/Leased Line Operation

Dedicated line operation is the simplest to set up.

• Set Dedicated connection

• Set PPP connection

CV: Use the Link Configuration: WAN 0 Dialog Box.

TB: Use configure and set the Mode and ConnectMode keywords in

the Link Config WAN 0 section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame-

ters for operation.

Required for Dial-On-Demand Operation

Incoming dial-on-demand operation requires only slightly more infor-

mation than dedicated line setup. Outgoing dial-on-demand requires

additional information (see the suggested settings below).

• Set dial-up connection

• Set PPP connection

• Set to allow dial-in and/or dial-out

CV: Use the Link Configuration: WAN 0 Dialog Box.

TB: Use configure and set the Mode, ConnectMode, DialIn and/or

DialOut keywords in the Link Config WAN 0 section.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Keine Kommentare

Compatible-systems MicroRouter 900i Bedienungsanleitung Seite 27