Compatible Systems MicroRouter 900i Installationsanleitung

DS3-10/100 RIOP Installation GuideCompatible Systems Corporation4730 Walnut StreetSuite 102Boulder, Colorado 80301303-444-9532800-356-0283http://www

Chapter 2 - Quickstart Configuration 6Suggested for AppleTalkYou may want to set your own network numbers, rather than using the autoconfigured values

Chapter 2 - Quickstart Configuration 7PPP ConfigurationThis section covers the settings required for PPP (point-to-point) protocol operation of the DS

Chapter 2 - Quickstart Configuration 8DECnet ProtocolRequired for DECnetThe router’s shipping configuration does not have DECnet turned on. In order

Chapter 2 - Quickstart Configuration 9IP ProtocolThere are two ways to set up Frame Relay. One is to set the WAN interface as a “numbered interface.”

Chapter 2 - Quickstart Configuration 10TB: Use configure and set the Numbered and Net keywords in the IPX WAN 0 section.Suggested for IPXThe settings

Chapter 2 - Quickstart Configuration 11SMDS ConfigurationThis section covers the settings required for SMDS (Switched Multi-megabit Data Service) oper

Chapter 3 - Shipping Defaults 12Chapter 3 - Shipping DefaultsEthernet InterfaceIP Routing Defaults• On• Address: 198.41.12.1• Subnet Mask: 255.255.255

Chapter 4 - LED Patterns 13Chapter 4 - LED Patterns Some of the LEDs on the front of the VSR multigigabit switching router serve dual functions. In a

Chapter 4 - LED Patterns 14DS3-10/100 RIOP LED PatternsThe following LEDs and light patterns provide information about the DS3-10/100 RIOP inter-faces

DS3-10/100 RIOP Installation Guide, Version 1.0Copyright© 1999, Compatible Systems CorporationAll rights reserved. VSR, VSR-2, MicroRouter and Compa

Table of ContentsiIntroduction to the DS3-10/100 RIOP 1Chapter 1 - Network Installation 2Ethernet Connection Requirements 2DS3 Line Connection Require

Table of ContentsiiIP Protocol 9Required for IP Numbered Interface 9Required for IP Unnumbered Interface 9Suggested for IP 9IPX Protocol 9Required for

Introduction to the DS3-10/100 RIOP 1Introduction to the DS3-10/100 RIOP The DS3-10/100 Routing Input/Output Processor (RIOP), as part of the VSR mult

Chapter 1 - Network Installation 2Chapter 1 - Network InstallationDS3-10/100 RIOP Front PanelThis section of the manual will help you install the DS3-

Chapter 1 - Network Installation 3Connecting the DS3-10/100 to the EthernetIf your twisted-pair hub is already in place, you can connect the router to

Chapter 2 - Quickstart Configuration 4Chapter 2 - Quickstart ConfigurationThis chapter briefly discusses the major parameters that must be set in orde

Chapter 2 - Quickstart Configuration 5Ethernet Interface ConfigurationEthernet interfaces are considerably easier to set up than WAN interfaces since