Compatible Systems MicroRouter 900i Bedienungsanleitung PDF herunterladen (Seite 17)

Section 3 - CNC Machine Installation - 17Microrouter CNC Machine User's Manual

3: Connecting your PC to the Microrouter

Your Microrouter CNC machine is controlled using a standard IBM

compatible PC (personal computer). In this role, the PC can be

referred to as the machine controller computer.

Ideally, the PC you intend to use should be placed next to the

Microrouter, in a position which will not interfere with routine

maintenance and machine operation.

Your PC must be equipped with hardware that allows it to:

1) run the CNC Machine Control software.

2) be physically connected to the Microrouter.

The specification of PC required to control your Microrouter will

depend upon the type of CNC machine controlling software being

used. Please refer to your separate CNC machine controlling

software manual for details regarding the exact PC specification

required.

3: Electrical Diagrams

The Electrical Diagrams for your Microrouter are not included in this

manual - they are delivered separately in the standard equipment

box supplied with your machine.

Do not connect cables

between any electrical

hardware with the mains

power switched on,

since this could

seriously damage

components inside your

CNC machine.

Warning

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 93 94

Keine Kommentare

Compatible Systems MicroRouter 900i Bedienungsanleitung Seite 17