Compatible Systems MicroRouter 900i Bedienungsanleitung PDF herunterladen (Seite 67)

Section 9 - Technical Support - 67Microrouter CNC Machine User's Manual

VR CNC Milling Software Communications Troubleshooting:

1) Your computer communicates with your Microrouter using an

RS232 serial cable. Check the RS232 cable is securely plugged

into a valid COM port on the computer. Note that COM ports are

sometimes labelled as serial ports. Identify whether the COM

port being used is labelled as COM1 or COM2. The opposite end

of this cable is securely plugged into the RS232 port located on

the right end panel of the Microrouter cabinet.

2) Check all mains power connections are correctly fitted and

secure. Power up the Microrouter, using the square, red, on/off

switch, located on the right end panel of the Microrouter cabinet.

The switch illuminates when power is being supplied to the

machine. If no power is present, switch off the mains supply,

then wait at least 5 minutes before removing the electrical access

plate. Check the condition of the on/off switch and fuses. For

more information, refer to Section 8 - Machine Electronics.

3) Start the VR CNC Milling software. From the main menubar at

the top of the VR CNC Milling software screen, click “Setup |

Setup Machine Parameters”. You may be required to enter a

password. The default password is “denny”. Type the password

and click [OK]. The "Machine Properties" window will open. You

can configure the type (name) of CNC machine attached to your

pc and any COM port settings from this window.

4) The “Machine Properties” window will open with the name of the

current (active) machine highlighted and its listing expanded.

Note that there are a number of Microrouter versions to choose

from. The active machine name in the software must match the

name and version of your CNC machine - this information is

printed on the CE identification panel, usually applied to the back

panel of the Microrouter cabinet.

For example, if “Microrouter Version 3” is printed on your CE

identification panel, the VR CNC Milling software must have

“RouterV3” set as the active machine. If the correct machine

name is NOT listed as the active machine, right click over the

required machine name title to display a pop-up menu. Click

“Make Active”, then click [OK] and restart the VR CNC Milling

software. Re-open the "Machine Properties" window to check

that the changes have been applied.

The password used to

access the "Machine

Properties" window can

be changed by the user.

Remember that the

default password listed

here will not be

recognised if you have

changed it.

If you change any

passwords, we

recommend you make a

note of them in the

Notes section in this

manual.

Note

9: Troubleshooting

Your screen may display

the message "Error 50

Mint 3.28 Disconnect"

(or similar, depending

on the hardware fitted).

Note

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 93 94

Kommentare zu diesen Handbüchern

Keine Kommentare

Compatible Systems MicroRouter 900i Bedienungsanleitung Seite 67

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Compatible Systems MicroRouter 900i