Compatible Systems MicroRouter 900i Bedienungsanleitung PDF herunterladen (Seite 19)

Section 3 - CNC Machine Installation - 19Microrouter CNC Machine User's Manual

3: Connecting your PC to the Microrouter

25 pin D female connector

fitted to RS232 cable (using

a 9 to 25 pin adaptor).

25 pin D male

connector

fitted to pc

(back) panel.

Short (standard)

9 pin D COM

port.

9 pin D female

connector fitted

to RS232 cable.

9 pin D male

connector

fitted to pc

(back) panel.

Long (PCI card

mounted) 25 pin D

COM port.

25 pin D

male

connector on

security key

(dongle).

25 pin D

female

connector

fitted to pc

(back) panel.

4) Connect the remaining 9 pin D female end of the RS 232 cable to

the 9 pin D male COM port on your PC, ideally COM 2. Most

computers usually have two COM ports situated on the back

panel of your PC. If you cannot identify any of the ports on your

PC, please refer to your original PC manufacturers operating

manual for further guidance. Note that older computers may be

fitted with a 25 pin D male COM port, which may require the

fitting of an additional 9 to 25 pin adaptor to your RS 232 cable.

5) Do not confuse the 25 pin D female

parallel (printer) port on your PC with

the 25 or 9 pin male D COM ports. If

your CNC machine control software is

supplied with a security key, the 25 pin

D male connector of this key must be

fitted to the 25 pin D female parallel

port, as shown right. Security keys are

also referred to as dongles.

A schematic diagram illustrating these

component connections is shown on page

22.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 93 94

Kommentare zu diesen Handbüchern

Keine Kommentare

Compatible Systems MicroRouter 900i Bedienungsanleitung Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Compatible Systems MicroRouter 900i