Compatible Systems MicroRouter 900i Bedienungsanleitung PDF herunterladen (Seite 48)

48 - Maintenance - Section 7 Microrouter CNC Machine User's Manual

7: Maintenance Schedule and Charts

If your CNC machine is used intensively, we recommend that the maintenance

tasks listed in the above schedule are performed on a more regular basis.

Note

Lubrication Chart.

Maintenance Schedule.

Lubrication Point Lubricating System Frequency Recommended Oil Quantity

Slide ways, Aerosol spray can As required Silicone based lubricant As required

Leadscrews &

Thrust Bearings.

Daily • Clean and remove any swarf.

• Check that all the sliderails and leadscrews are lubricated.

• Clean the tooling and laminate trimmer (machine head).

Weekly • Clean the machine.

• Check all exposed screws and nuts for tightness.

• Lubricate all sliderails and leadscrews.

Biannually • Check the condition of any electrical connections.

• Check and clean tooling collets.

• Check all cables for kinks and breaks.

• Check the condition of any drive belts.

• Clean the 3 axis datum microswitches.

Annually • Check the slides for wear.

The laminate trimmer motor has been lubricated with a sufficient amount of

high grade lubricant for the life of the unit under normal operating conditions.

No further lubrication is necessary.

Never use light machine oil, in place of the recommended silicone based spray, for

machine lubrication. Always read the instructions supplied with any silicone

based lubricant before use. Never use silicone based lubricant on any other

type of machine unless specifically stated.

Note

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 93 94

Keine Kommentare

Compatible Systems MicroRouter 900i Bedienungsanleitung Seite 48