Compatible Systems MicroRouter 900i Bedienungsanleitung PDF herunterladen (Seite 46)

46 - Work Holding - Section 6 Microrouter CNC Machine User's Manual

6: Fitting and Using the Vacuum Table

To operate the vacuum table:

1) Place the vacuum table on the Microrouter floor, with the multiple

air valves and cells facing upwards, so the hole in the centre of

the Microrouter floor is completely covered.

Run the integrated

vacuum pump only

when using the vacuum

table. Denford

recommends a

maximum continuous

running time of 30

minutes, unless

demanded otherwise

due to the length of the

CNC program in use,

with a 10 minute break

to ensure the optimum

life for the vacuum

pump motor.

Note

2) The vacuum pump switch is fitted to the front control panel,

located on the right side of the Microrouter cabinet. Switch on

the vacuum pump by lifting the cover and pressing the square,

green, button once.

The switch becomes operational when a successful

communication link is established between the Microrouter and

the CNC machine controller PC. A vacuum seal will be created

between the lower surface of the vacuum table and the

Microrouter floor, holding the vacuum table in position.

Vacuum

table in

position.

Position the vacuum

table so this hole is

completely covered.

continued...

Left: Vacuum pump

switch (circled) on the

machine control panel.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 93 94

Keine Kommentare

Compatible Systems MicroRouter 900i Bedienungsanleitung Seite 46